Kit Repair Porcelain - PORC-a-FILLER - Porcelain Chip Filler

Product Information

Utilise the same method when working with porcelain paving tiles as with working with stone or concrete. The base on which the porcelain is laid must be able to drain. If the base is non-permeable then EASYJoint Pro or EASYGrout should be used. Fill a container that is slightly larger than the piece you want to prepare with plastic pebbles, rice, or sand. This will cradle and hold the repaired piece still and in place while it cures. Finally, do a dry run of how the pieces will fit together. Have you had a hard time looking for the best porcelain repair kit? How about a complete set capable of fixing many surfaces? The Cal-Flor FL49106CF Mix2Match Repair Kit is a repair kit that is easy to apply and use for everyone.

selected areas. Clean the entire piece with alcohol to prepare the surface for painting and cold glazing to hide the repair lines. To make sure this area is totally dry, carefully wipe just the repair area with a small amount of acetone after cleaning. You can now use sandpaper to do the final touches and leave the best finish. If you consider the color doesn’t match with the rest, consider painting over it. Frequently Asked Questions Q1. What Is a Porcelain Repair Kit?

Benefits of Using Porcelain Repair Kit

Zero Waste – Opened tubs of EASYJoint, if not fully used, can be kept for later use providing they are covered by a minimum of 2″ (50mm) or more of water

Yes, theoretically EASYJoint can be used below 3 degrees down to freezing conditions, however in these conditions, the use of lots of water becomes more difficult with a greater risk of staining. Where possible avoid using below 3 degrees, use with caution. Does EASYJoint stain paving slabs? Top Up Low Spots. Use more EASY Joint to top up any low spots in your joints, repeating the washing process as described previously.You never know when an accident might cause chips on any of these surfaces, and having a versatile kit might help us save. 2. The Right Color EASYJoint brush-in patio grout , is a really simple, fast and DIY friendly way to fill the joints in paving slabs and flagstones. Market-leading EASYJoint is ideal for all types of paving such as natural stone, limestone, porcelain, sandstone, Yorkstone, Indian Stone, granite setts and concrete flags. Mix. Mix the resin and hardener together for the length of time specified on the product’s instructions. Sand the filled area, once completely dry. Use the 220 grit sandpaper to remove any surface imperfections and ensure that the fill is slightly below the porcelain surface to allow for the glaze application.