Skinny Clip Waistband Tightener,Replace Belts For Women & Men,Hold Up Your Pants,Waist Cincher Clip,Adjustable Skirt, Short, Jean, & Pant Waist Tightener,Multicolor 4 Pack, Blue, one size fits all

Product Information

But it became fashionable a few years ago to have them wider – normally 5cm but sometimes even more. These were then sometimes fastened with two buttons at the end, rather than one. The end could also be split in two, adding another unusual detail. Thanks AMS. That’s a very good point about the historical change and importance of width, I hadn’t thought of it like that. I add a restrictive requirement, that also makes sorting easier : I mainly wear a size 44, sometimes a size 46. Tailored trousers and frequenting pubs could provide serious challenges. Do you risk the embarrassment of having waited too long before excusing yourself and darting off to the bathroom? Or would it be preferable to just rip the fly open and experience the momentary joy of relief? Tough one here…

Wide Waistbands Pre-Made Waistbands All Sizes Heavyweight Cotton Spandex Waistband Elastic Women Skirts Yoga Pants Twinklewear Because a turn-up interrupts the line of a trouser – making it look less sleek and smart – it is generally seen as more casual than a plain-bottom. I’m pretty late to the game here but I still find useful info in comments on older posts on permanent style so thought I’d park some thoughts here. with my suit and waistcoat buttoned as I stood up, I counted the number of individual buttons I had to carefully undo as I danced like a madman in front of the toilet… more than 14 buttons (including the one on your boxers) after a few poses quite a challenge, gentlemen!In America they’re cuffs, in the UK they’re turn-ups. Some even call them PTUs (Permanent Turn Ups). This is less showy than the big waistbands, but still (for me) was a style whose appeal didn’t last.

Until recently I have not a clear answer from any “tailor” as to why the adjusters should be on the waistband or below it or between the two. I’m 5’6″, lean and want to experiment with cuffs for a pair of tapered trousers. Do you think 1¼ or 1½ would be appropriate?Also, concerning button fly – do tailors usually reinforce the piece that buttons go through with thin lining, or is it just one layer of the trousers cloth for them? Find a pair of pants - jeans work well because of the strong button - and wet the waistband. Zip up the zipper, button the button, and insert the stretcher as shown. Squeeze the handle until the waistband is quite tight, but not so tight you pop the button (dress pants might be inclined to lose buttons because they aren't as firmly attached.) As they dry, they will stretch the fabric and give you a little breathing room. Sorry Simon, but it is p[recisel;y because you did mention it that I raised the point. “Some even call them PTU’s”. Button flies are certainly more interesting to the fairer sex, but be prepared for the occasional tragedy! I know Daks adjustors have their fans, but personally I don’t want elastic in my waistband if I can help it. And in any case they never work as well as a side adjustor. Elastic stretches as you reach and as you move; trouser cloth on its own does not.

Finally, I usually prefer a waistband to finish in a button on slightly more casual trousers, but a hook on smarter ones – as it’s cleaner. But it’s more personal preference than almost anything else here. Mentioning that they used to be called permanent turn ups would certainly be educational, but a very minor point, and I’m afraid there isn’t room in an article like this, which tries to cover so much, for everything minor.As regards button or zip fly, buttons are more traditional, involve more work and arguably help the front sit slightly flatter. I’ve never noticed much difference, however, and after a few pairs with buttons, always go with a zip. It’s much easier and more practical – and was good enough for the Duke of Windsor almost a century ago.

If there’s anything you think we’ve left out, please do ask in the comments. It all helps with the comprehensive-ness and future reference-ability. I’ve been in nothing but bespoke for over 30 years. A tailor will ask you if you want turn ups (layman’s term), and if you say yes he will write PTU’s. Simple. This is what I’ve learned from converting maybe a dozen or so pairs of RTW trousers to side adjusters a One thing I think is worth mentioning is that a zip fly is a lot less flexible than a button fly, and for those who prefer trousers with pleats (particularly double pleats), a zip fly can give you a bad case of ‘pants tent’ or ‘jeanis’ when you sit down. Easy to fasten onto your button fastener on a pair of trousers or a skirt, this waist extender will give you extra breathing space of 1" to 2", ideal to relieve that bloated feeling after a meal. Ideal to easily adapt trousers and skirts during pregnancy or during a period of weight gain, this waist expander is available in a choice of colours to match a range of garments.Again this is cultural and influenced by fashion. The Italians are much more likely to wear a belt with their suits. Though I still think it looks sloppy.