Dryrod Damp Proofing Rods (50 Pack) - BBA-Approved Rising Damp Treatment, Stronger Than DPC Injection Creams. Coverage 6m

Product Information

After some research I have found I have rising damp, one of the issues was that the previous owner brought the garden walkway outside higher than the damp proof course. So I dug the side of the house out and put some damp proof rods in, the inside massively got better and became much dryer but not fully dry. Strangely, where I have drilled my hole and put my damp rod, it seems wet along this mortar joint. Is this normal? If so I worry that when I get it plastered, the damp will just travel up the plaster again as it will soak it in. The active-ingredient and water repellent contained within each rod, carefully spreads the correct dosage into the wall. As a result, when it bonds with the mortar, a lasting solution to the problem of rising damp is delivered. What Conditions Can You Use Damp Proof Rods In? Also bear in mind that 1. The wall will never completely dry no matter what you do, and 2. It will take multiple annual cycles to dry out and find a new equilibrium with a lower moisture level, assuming your remedial treatments are successful.

A high-strength silicone cream will do the job too of course. The cream is injected into holes, that have been drilled at regular intervals along a mortar course. This forms a DPC in much the same way to damp proof rods. The cream diffuses along the course and forms breathable water-repellent protection. This prevents damp rising up the wall. Dryrod Damp-Proofing Rods are the latest innovation in rising damp treatments. They are patented 12mm diameter grooved fibre rods that carry a powerful water repellent material. Dryrod has been thoroughly tested and is independently approved by the British Board of Agrement. Why Dryrod is Required Looking at my front door, there is loads of foam around the side and none in the top in which I can see daylight in the top. I have a new door to be installed in the next few months to eliminate the door being the issue.For the confident DIY enthusiast, installing damp proof rods should not present any real problems. However, it is important to remember that any DIY damp proofing project comes with a caveat. Just wondering what everyone else's thoughts on this is? The floor on the inside, is a concrete floor and does not appear to be wet. As you can see from image from right to left, there is two wet holes, this is where damp rods are, once getting to the corner it still looks damper than the rest..... the cement was scrapped over yesterday so should be fully dry now.

The active ingredient contained within the rods spreads through, and bonds with, sand;cement mortar. Any continuous mortar line that has been properly treated with Dryrod Damp-Proofing Rods becomes a damp-proof course. Due to the unique formulation of active ingredient allowed by the design of the rods, a Dryrod treatment is over 4 times more effective than the next best treatment method. How Dryrod is Applied Dryrod Damp-Proofing Rods are patented fibre rods that carry a powerful water-repellent material. They are simply inserted into holes drilled at regular intervals along a mortar course. Once inserted, the rods diffuse their water-repellent material along the mortar course, curing to form an effective barrier to rising damp. Similarly, with both low and high alkalinity mortar, or low and high porosity mortar, the rods will still deliver the goods. No specialist equipment required - simply insert into 12mm holes in the mortar lines of a building to form a powerful waterproof barrier The damp started in a corner near the front door, then went the stretch of the wall and went up the wall, it still looks it might be in the corner but on the stretch of wall it seems to stop at the damp rods but is on the damp rod level and below.

Certificates

The effectiveness of the DPC, will be dependent on how accurately the damp proof rods are installed. Having said that, to all but the DIY novice, the installation of damp proof rods should not require the services of a professional. Start by drilling your holes. Using a 12mm drill bit, find the lowest horizontal mortar course. Next drill holes at 120mm intervals. As you approach the final 40mm of intended depth, release the pressure you are applying on the drill. Failure to do so could result in excessive pressure, which can cause damage to the other side of the wall.

BBA Approved – The High-Performance DPC Treatment is Certified by the British Board of Agrément to be effective against the ingress of moisture for at least 20 years They have been scientifically proven to eliminate rising damp even in highly-saturated walls. This performance has also been internationally tested and approved. A concrete internal floor won't be helping, this prevents any evaporation below floor level, so can trap water in the wall. Laboratory testing has proven that Dryrod Damp-Proofing Rods out-perform competing treatment methods, even in highly-saturated walls and freezing temperatures. They have also been approved by the British Board of Agrement and the German WTA organization.Finally, damp proof rods can be installed into both warm and cold walls. Indeed, they will even be effective in freezing conditions. How Do You Apply Damp Proof Rods? Dryrod Damp-Proofing Rods Next Generation DPC - The most effective form of damp proofing for walls; outperforms creams, gels or liquids.

The coverage rate will vary depending upon the roughness and absorbency of the surface, use as a guide only. AppearanceTraditional rising damp treatment methods utilise cream or liquid injection. These methods can be prone to operator error leading to under-treatment and DPC failure. Due to their unique patented design, Dryrod Damp-Proofing Rods deliver the correct dose of active ingredient every time. Damp proof rods have emerged as a genuine alternative to even the highest quality DPC creams. Proven to be effective even in highly saturated walls, damp proof rods outperform even the best creams on the market. The good news is that damp proof rods can be installed in pretty much all conditions. Even with heavily saturated walls (as much as 95%), damp proof rods will be effective.