Brasso Metal Polish Wadding, 75g

Product Information

In addition to this, if you’ve used an appropriate amount of Brasso, and you’ve worked it into a surface and then buffed the surface again, you shouldn’t really have any excess Brasso left behind. So, you won’t need to ‘wipe Brasso off a surface’ per se. Brasso has been successfully used to take minor (white) heat marks out of French polished wooden surfaces. The fine abrasive cuts through the surface and allows the solvent into the wax and lacquer layer. The surface should be properly cleaned and waxed after this treatment. To use Brasso Metal Polish Wadding remove the wadding and apply evenly to the desired metal surface in small circular motions Tip: If you’re using liquid Brasso, always pour the liquid from the can onto a clean cloth. Do not hold a cloth over the mouth of the can because this transfers dirt into the can. This then contaminates and weakens the Brasso inside the can. How to clean with wadding Brasso: Brasso is a well-known metal polisher, that can be used to polish, remove tarnish and clean up chrome, stainless steel, copper, and of course, brass.

If you buy a liquid can of Brasso, you need to pour a small amount of the can’s contents onto a clean cloth to use the solution. Brasso, if used correctly, will naturally be worked into a surface, and any residue will be buffed away by a clean cloth at the end of the exercise. If you wish to return this item to Robert Dyas, you can only do so by the following method: 1. Visit Your Local Robert Dyas Store Below you’ll find steps on how to use Brasso in both liquid and wadding form. Skip to the section that applies to the Brasso you’ve bought. General tips to think about before you start using Brasso:

Brasso Metal Polish Wadding has been in use for over a century - it has truly stood the test of time - and this product will continue to maintain the lustre of metal surfaces in the future. How To Use Although, if you’ve used an appropriate amount of Brasso for the surface you need to clean, and you’ve worked the Brasso into the item and buffed it as well, there shouldn’t be any need to remove the Brasso with water. This is not intended to be a full statement of your rights under the Consumer Contracts Regulations. Full details of your rights are available from your Local Authority’s Trading Standards Office. How To Return A Product Perform a small patch test to make sure the Brasso doesn’t mark or stain the surface you’re about to polish.

For use on brass, copper, stainless steel and chrome, this product has been specially designed to provide excellent results and a longer lasting shine. Technically speaking, as you continuously massage Brasso into the surface you’re polishing, you will be wiping some of the product off as you go. This is what’s supposed to happen. When you’re done using your Brasso you need to store it away in a safe place, that is out of the reach of children and pets. Continue to do this until the patch is clean – you might need to apply more pressure to certain grimey patches.If you do have Brasso residue leftover, either keep buffing it off the surface or use a clean cloth to remove it.

Anything of a nature that for hygiene or associated health and safety - this includes the Outdoor Spas, Mattresses and Divan Sets Use small amounts of Brasso at a time, and add more product as you go– If you use too much Brasso you run the risk of it dripping everywhere as you use it, especially the liquid form, this is wasteful. The label of Australian Brasso lists "Liquid Hydrocarbons 630g/L; Ammonia 5g/L", whereas the material safety data sheet for Brasso in North America lists: isopropyl alcohol 3–5%, ammonia 5–10%, silica powder 15–20% and oxalic acid 0–3% as the ingredients. [4] However, the Australian version contains kaolin instead of silica for abrasives. [5]If you’ve got some stubborn Brasso that needs to be cleaned away, follow these steps to get rid of the troubling Brasso: Note: You’ll likely have to use more Brasso for tougher, dirtier spots! And if your Brasso cleaning cloth goes dry, add more liquid Brasso to it or use a new piece of wadding. Benefits of using Brasso Church, Roy A.; Andrew Godley (2003). The Emergence of Modern Marketing. Routledge. p.30. ISBN 0-7146-5390-X.

Always wear gloves and a mask– Brasso can cause skin irritation and inhaling the fumes may lead to drowsiness. Brasso can be bought from most hardware stores and supermarkets. You’ll typically find it near to, or in, the cleaning products aisle.

We Recommend

Keep an eye out for a blue and white striped pot that has a big red label on the front, with the name ‘Brasso’ on it. Railway And Canal Commission." Times [London, England] 22 May 1913: 22. The Times Digital Archive. Web. 13 Sept. 2018. You’ve got to put some elbow grease into the cleaning exercise – it’s not just going to work on its own. Regularly wipe/buff the already treated surface with a new clean cloth to see how you’re polishing exercise is going. Brasso is abrasive and will wear metal over time. The National Trust recommend alternative cleaners. [7] Other applications [ edit ]