276°
Posted 20 hours ago

SKYLITE SYSTEMS Pleated Blind suitable for Velux windows - White (GGL 5)

£9.9£99Clearance
ZTS2023's avatar
Shared by
ZTS2023
Joined in 2023
82
63

About this deal

No, Knauf AQUAPANEL ®Floor Tile Underlay is not approved for installation in a vertical installation. No, this board should only be used for internal applications. Knauf offers Knauf AQUAPANEL ®Cement Board Outdoor (which is freeze thaw tested) for exterior uses. Several methods can help to decide on the size and spacing of skylights. The size of the skylight impacts its solar heat gain and its conduction gains and losses. Typically for roof windows and skylights, a 3–5 per cent floor-to-skylight area ratio is used and for some high-performing tubular skylights, 1–2 per cent is sufficient. If multiple skylights are to be used in the same room, spacing between the skylights should be 1.5 times the height of the room.

What was the previous process for entering a new case? How has including Bing Maps in the app helped? The combination of Office 365, SharePoint, Power Apps, Power Automate and Bing Maps is UNBEATABLE. The price, capability, and possibilities are unmatched and head and shoulders above anything in the marketplace. The customer LOVES it and there are MANY customers who could use a similar solution.We recommend that the smooth face is rendered onto. If the boards have been installed rough side out, make a note of the batch number against the project name and render can be applied to the rough side. Knauf recommend that the boards are installed with a 3 to 5mm gap all around the boards, and all joints are taped and jointed using Knauf AQUAPANEL ®products (this must be done for soffit applications). If the thin coat render basecoat and mesh layer is going to be applied within 4 to 6 weeks of the boards being installed, the tape and jointing application can be omitted, but the basecoat must be applied into the gaps prior to application of the basecoat and mesh layer. Yes, as a full board, a radius of down to 3m is possible. If the board is cut into 300mm strips, then a radius of as little as 1m is achievable. Knauf AQUAPANEL ®Cement Board Outdoor is A1 rated to EN 13501; it is therefore non-combustible and will not allow fire to spread along its surface. However, as the board is installed over a drained and ventilated cavity, any fire may get behind the cladding. A timed fire rated walling system would be accomplished from the sheathing layer inwards. Cavity fire stopping should be discussed with the passive fire stopping specialists on the scheme.

Yes, the cladding must be ventilated at the head of the cladding with a minimum gap of 10mm between the top of the rendered cladding and the structure above (soffit box, coping etc.). This allows any warm moist air to escape from the cavity.Wet areas such as rooms housing swimming pools, spas and saunas, wet rooms, kitchens, laundries, bathrooms, changing rooms, domestic and commercial kitchens, restaurants or anywhere where ceramic, mosaic or stone floor coverings are specified. No, we do not recommend this as the cement is not a good conductor of heat and, due to the fixings, should not be installed directly over an insulation material either. An UFH system which is installed in the tile adhesive layer, over the board, would be OK. Knauf AQUAPANEL ®Cement Board Outdoor has a mass of 16kg/m². 1200mm long board is 17.28kg and 2400mm long board is 34.56kg. As the board is lightweight and only 900mm wide, it means that it can easily be worked from scaffolding, rather than having to be cut on the ground and carried to the fixing position.

A wide variety of our skylight products and configurations have been subjected to the Hurricane Rating and Bomb Blast Resistant Test. Our skylights held up to Hurricanes Luis and Lenny — both extreme hurricanes with winds in excess of 225 miles per hour, ultimately proving our creations are strong even in the toughest of circumstantial conditions. Besides tests, our durability shows with over 40 years of successful installation projects. We recommend you use a cement-based flexible tile adhesive (Class C2 / S1 according to EN 12004 - 12004). If you need better waterproofing than just the tiles, use a waterproof adhesive provided it is cement based. New build insurance providers state that the cavity needs to be a minimum of 25mm in England and Wales, and 50mm in Scotland, Northern Ireland and Republic of Ireland.

Follow Us On

No, the boards can be left without the 3 to 5mm gaps being filled for between 4 to 6 weeks before the modern thin coat basecoat, mesh and finish have to be applied to weathertight the facade. Apply the thin coat basecoat into the gaps before applying the full surface application. Knauf AQUAPANEL ®Joint Filler - Grey, AQUAPANEL ®Tape, AQUAPANEL ®Screws (dependent on framework type), and exterior thin render coat system (incorporating a modern thin basecoat and mesh, and a finish coat). Yes, where Knauf AQUAPANEL ®Cement Board SkyLite is not being sourced, Knauf AQUAPANEL ®Cement Board Indoor can be used to form a soffit system, along with the coated metal framework also offered by Knauf. How long can the Knauf AQUAPANEL ®Cement Board Outdoor be left exposed before I should render them?

Asda Great Deal

Free UK shipping. 15 day free returns.
Community Updates
*So you can easily identify outgoing links on our site, we've marked them with an "*" symbol. Links on our site are monetised, but this never affects which deals get posted. Find more info in our FAQs and About Us page.
New Comment