Drayton 24028 RTS8 Combi-Stat Room Thermostat, White

Product Information

If the valve is a 15, 10 or 8mm angled body then it can be fitted in either flow/return, horizontally or vertically.

If the valve is in the ‘Heating’ only position when the room thermostat becomes satisfied, then the valve will remain energised consuming some power and may be warm to touch. This is normal. Programmers My Digistat +2/3 appears to switch off before my set point is reached and sometimes remains on after my set point is reached, is this normal? The Digistat is universal because it can be used as a fully-programmable thermostat or as a simple manual thermostat. In fact it contains 4 types of functionality: The thermostat is not communicating with the receiver. Replace the batteries in the thermostat. Re-commission the 2 units.Weather compensation - Wiser satisfies this measure because Eco Mode combines weather compensation and optimum stop The 15, 10 or 8mm angled body is bi directional as denoted by the double-headed arrow on the valve body. All other bodies are flow directional as indicated by the single headed arrow head on the valve body. The Digistat qualifies as one of the additional measures required when replacing a boiler. In fact it qualifies both as a Smart Control and as Load Compensation. Most actuator heads can be removed so you can watch it operate without it being on the valve spindle. try HW only (start positon) then HW - CH (mid positon) and watch it move to mid positon, then CH only and see if it moves to the final positon. The actuator head of a ACL Lifestyle 2-port motorised valve (679H308-30L1) has failed. Is it still possible to get the actuator for this valve to avoid draining the whole system?

What should be done when E1 appears on the screen of a room thermostat. Does the whole wireless system need replacement? We manufacture two different types of sensor kits. One is described as a remote sensor and the other as a setting kit.

Typically 30M, however building construction and materials may effect this. Signal strength test should be carried out. Smart controls - Wiser satisfies this measure thanks to Eco Mode and Comfort Mode, both featuring optimisation and the 7 day scheduling within the app for automation.

These batteries are factory fitted and not designed to be user replaceable. Unauthorised removal of the battery could damage the unit. TRVs I have a Drayton TRV4 thermostatic valve on the radiator. Is it correct that it can be installed on both the Flow or Return and can be mounted either horizontal or vertical?day programming: The most flexible option allowing you to schedule every day of the week independently. To shut the valve off permanently use the plastic decorator cap that comes supplied with the valve, the valve will remain shut no matter what the temperature. The Drayton range of products offers a solution for both combi and non-combi installations, meaning you can continue to fit the thermostats and time controls you know and love, safe in the knowledge that your installation will meet with the new Building Regulations. Yes, there is a Digistat to suit both types of boiler – try our product selector to find the right one for you. Load compensation - Many Drayton products meet this measure due to the algorithms used in their software, including Wiser, the full Digistat range and the LP Clip-in controls

The Digistat remembers the last BOOST so if you always use the same parameters just press the O button 3 times. Simple! When controlling a non-combi boiler, you need to fit time and temperature controls. Examples of solutions from Drayton are below:

I have a Digistat RF and I have managed to snap one of the clips on the battery holder. Where can I obtain a replacement No, E1 is an error code that means the internal sensor has failed. The sender unit will have to be replaced. This range of valves and actuators are now obsolete. Your only option is to drain down the system and fit ZA 5/6 zone valve. If the installation is a combi boiler (both new and replacement) ONE of these additional measures needs meeting.