Danfoss HSA3 3-Port Valve Actuator

Product Information

A few weeks ago, I had some issues with my heating. The fault was found to be a damaged cable in the Kitchen wall, which was repaired / replaced. At the same time I found the 3-way valve in the airing cupboard to be leaking when set for heating. For the last few weeks I have had the 3way valve actuator wiring disconnected and have just been using the system for hot water. Continue to save even more money by taking advantage of the Bathrooms and Showers Direct Customer Loyalty Programme. The power to start boiler then comes from cylinder stat if HW is involved or the valves orange wire if HW not involved. When the system is off, the actuator is returning to CH only too.. I'm sure it used to return to HW only ?

Wiring is not my strong point. A customer with an open vented boiler has hot water but no heating. I suspect the danfoss 3 port valve. There are 4 wires: orange (switched live), grey (hot water off), brown & white (heating on) and blue (neutral). It may be that HW is not on so the grey would not become live and this is where the second source comes in. Today I finally got round to replacing the 3-way valve body and put a new (but not tested) actuator head on as the old one had visible signs of water damage. Wire (1) comes from the HW ON terminal, (goes via junction box) to cylinder stat, then across the stat, then from cylinder stat (via junction box ) to boiler/pump. I was expecting the orange to become live once the valve had moved to the heating position but that’s not the case. It does become live and fire the boiler when hot water is selected.There are a number of reasons as to why a customer may want or need to return a product. This is a rare situation, however, if this does happen our objective is to make the process as efficient and easy as possible. If you continue, you will be logged-out of your Danfoss Store and directed to the Store you have selected. We provide a home delivery service through a number of leading courier agencies. Delivery charges are determined by how fragile, size and weight of the product(s) being delivered as follows:

Hi a Engineer has fitted a Actevator Valve. Danfoss, HSA3. the problem is,he does Not know the Wiring,which wire goes where?My question is, does the HSA3 electrical wiring need to be connected in the junction box to complete the circuit for the CH ? A wire from this terminal leads to the grey, which drives the motor forward to CH. While doing this a second micro switch allows power out of the valves orange wire to re start the boiler. Note the CH and HW will now share the flow of water until one side becomes satisfied (usually HW) when the valve is then supposed to move to CH only. The Danfoss port "H" motorised valve series, which includes the HSA3 Actuator, is suitable for use with both copper and iron pipes. The motor replacement head for the HS3 Valve bodies is the Danfoss HSA3 Actuator. By purchasing the actuator, you may just swap out the head of the device rather than having to replace the entire thing.