Global Ceramic Water Sharpener GS-440SS

Product Information

Keeping it at that angle, pull the knife down the honing steel while pulling the handle towards you. Repeat this action three to six times. You can go for three if your blade is just a bit dull, and more if it's blunter.

Each knife sharpener will have its own specific directions, and you should always follow those, but in general, you insert the blade into the slot and pull it through with even pressure several times. It's important to make sure the full blade passes over the abrasive, all the way from heel to tip. Then, you repeat the process on the other side of the blade (though some sharpeners work on both sides at once), first using the coarsest slot and then each of the finer ones.Manual sharpeners are generally cheaper and simpler to use, but they require more effort, so they may not be ideal for people with limited hand grip or arm strength. They're easier for a beginner to use correctly compared to an electric knife sharpener. We did not expect a knife sharpener at this low of a price to work as well as it does, but the Longzon 4-in-1 really delivers. As the name suggests, the manual sharpener has four slots—three successively finer ones for standard knives and an extra-wide one especially for sharpening scissors and shears. Some manual sharpeners take a little practice to use correctly, but the Longzon's design and included directions make things simple. There's even a QR code link to video instructions if you're more of a visual learner. Work Sharp Electric Culinary E2 Kitchen Knife Sharpener: This sharpener is easy to use and has an excellent price for an electric model, but you get what you pay for. We found that it did just an OK job at sharpening, while its feet let it slide around on the countertop, which is a definite safety hazard. Effectiveness: The Edge-on-Up tool helped give us an idea of each sharpener's efficiency, but we also tested our knives immediately before and after sharpening to gauge any noticeable differences.

A honing steel, sometimes also called a honing rod or a sharpening steel, doesn't exactly sharpen your knife. Instead, it realigns the cutting edge to smooth out microscopic bumps and jagged edges. If your knife sharpener has a fine or honing setting, run it through that once or twice after the coarse setting. Do this in the same way, but with less force. To keep your knife sharp, use the fine setting once after every couple of hours' use. This process is essentially the same with both a manual and electric sharpener, but the motorized abrasives in an electric model will do more of the work for you. The most important thing is to try to use the same amount of pressure and the same angle with each pull through the slot—different models of sharpener make this easier or harder, depending on their design. Unless the directions specify otherwise, it should take three to five pulls through the coarse slot, and then just a couple through each finer slot, to sharpen the knife. If it's not as sharp as you like, try a few more pulls through the finest grit slot, and if that doesn't work, try the whole process over again. Finish with a honing steel for best results. Rinse and dry the knife. You may also need to clean up the area around the whetstone.

Hold the knife at about a 22-degree angle to the stone. 90 degrees is your knife placed on the stone as if you were going to cut through it. Tilt the knife halfway between that and the whetstone and you'll be at 45 degrees. Then tilt it halfway between that and the stone, and you'll be at around the correct angle you need. Handheld manual knife sharpeners are designed to keep your blade fresh, and you should use them to top up the blade after every few hours of use. An electric knife sharpener or whetstone would be your best bet for a fully dulled knife.