FireAngel FA3313 Carbon Monoxide Detector and Alarm with 1 Year Replaceable Batteries (Replacement for FireAngel CO-9B)

Product Information

With a multi-functional LCD digital display and array of exclusive features such as Alarm Memory, Ventilate Instruction, Quiet Self Test and Environmental Sensing, the FA3322X4 offers the highest level of CO detection for your home.

FireAngel’s FA3322 digital carbon monoxide alarm features many icons on the LCD screen. View our guide below to help you understand what each represents. Find out more about what you should expect from your landlord for CO safety in your home. Get protected today FireAngel smoke, heat and carbon monoxide (CO) alarms are designed to be as maintenance-free as possible, however there are a few steps that must be followed to ensure your alarms continue to perform correctly. The below provides an overview of installing your carbon monoxide alarm, but please refer to each alarm’s manual for tailored guidance. Which room can I install this carbon monoxide alarm?

All alarms are calibrated and rigorously tested in-house and are third party tested to receive the BSI Kitemark certification to provide peace of mind. Also, the new range is compliant with the revised European Standard EN 50291-1:2018 to ensure maximum protection. FA3322X4: Carbon Monoxide Alarm with digital display and 10 year battery Free-standing installation: The base of the alarm has been designed to allow it to stand freely on a shelf where required. Read our handy guide for more information on correctly installing your alarms or discover why your Pro Connected alarms may be beeping in our guide. Dust contamination: How do I clean my alarm? Once your CO alarm is activated, this icon or ‘heartbeat’ will continue to flash a green LED in power mode. If a battery fault or warning has been silenced for a period of 8 hours and times out during night time, the silence period will automatically be extended once for a further 8 hours (night silence will increase the counter by 1 for sleep easy). Please note, this feature is not available with the FA3820 or FA3313 alarms. Understanding FA3322 digital display indicators

The alarm features the latest CO sensing technology and can be used to replace end-of-life FireAngel CO-9X alarms. Fitted with a sealed, tamper proof battery that will last the lifetime of the alarm. The sensors within the unit will deteriorate after 10 years, so to ensure you’re protected we recommend you replace the unit after this time. FireAngel recommend a CO alarm is installed between 1 m and 3 m away from each fuel‑burning appliance, as well as installing additional units in areas such as living rooms and bedrooms where you spend most time whilst at home. Activating your new FireAngel CO alarmWith our sleep easy function, you can silence low battery chirps for 8 hours, up to 10 times. This feature not only allows you to enjoy a silent night’s sleep, but gives you vital time to take action and replace your batteries. For alarms located in the same room as a fuel-burning appliance (for both wall and ceiling mounted alarms) the following applies: Where your alarm is installed can also trigger nuisance alarms if not correctly placed, for example too close to doors or windows. Guidance for where to install your smoke, heat and CO alarms can be found below. Using a soft brush adaptor, your vacuum or your hairdryer on a cool setting, run along the edges and face of the alarm. Please do not use any solvents or cleaners on your alarm as they may cause damage to the sensor or circuitry.

Find out more about the FA3820X4 CO Alarm. FA3313X4: Carbon Monoxide Alarm with replaceable batteries These alarms fall under the Waste Electrical and Electronic Equipment regulations (WEEE). The directive requires producers of Electronic Equipment to join a WEEE compliance scheme and contribute to the cost of recycling Waste Electronic Equipment that is collected at local recycling centres and other routes.With the alarm memory function, the red LED will flash to provide a visual indication of a previous CO alarm activation. The FA6813-EU offers electrochemical sensing technology and a clear loud alarm to ensure trusted carbon monoxide (CO) detection for your home. This alarm also features our new Crescendo Test, which helps to protect your hearing by allowing you to choose the volume level of the test alarm. Simply hold down the test button and the alarm will move through the increasing volume levels (similar to a rising ‘crescendo’) until you find the alert sound level you are comfortable with.