Seagate BarraCuda, 2TB, Internal Hard Drive, 3.5 Inch, SATA 6GB/s, 7.200 RPM, 64MB Cache, for Computer Desktop PC, FFP (ST2000DM008)

Product Information

I am attempting a new installation of a bootable Serial ATA drive in my PC and it is not detected correctly

Lyve: Periferie-naar-cloudplatform voor massaopslag Lyve Cloud: Voordelige objectopslag, ontworpen voor de multicloud Disconnect all external storage devices such as external USB, Firewire, and eSATA drives, jump/thumb/flash drives, cameras, and printers before proceeding with a Windows repair or recovery. Failure to disconnect such devices could result in serious data corruption.

Firmwaredownloads

Keuze uit een enorme opslagcapaciteit van 500 GB tot 2 TB. Profiteer van de hoogste capaciteit in de dunste 2,5-inch harde schijf in een slanke vormfactor die systeemupgrades eenvoudig maakt. Gemiddelde grootte van games is 35 tot 50 GB. Kwantitatieve gebruiksvoorbeelden zijn informatief bedoeld. Open the computer case and remove the data cable from the hard drive. This will stop any power saving commands from being sent.

Once you connect a new Serial ATA drive in your computer as additional storage, there remains more to do to get your drive working.

Meer dan 2 TB

Het opstartproces is vertraagd op een computer waarin een grote harde schijf is geïnstalleerd en waarop Windows 7 of Windows Server 2008 R2 draait Each Seagate hard drive engages in regular self-tests, and most computers automatically run regular SMART tests on the hard drive(s) installed on them. SMART tests indicate whether a drive is approaching imminent failure. Thus, if a SMART error appears suddenly, it virtually always means, unfortunately, that the drive is about to fail and should be replaced. Noises can be caused by mounting issues. This is due to either a high-frequency vibration in the mounting hardware or a potential drive failure. Before the drive can display in (My) Computer/This (PC) or Windows/File Explorer, it must be formatted in Windows. Please see the following articles for instructions:

If a Serial ATA drive, installed as additional storage in your computer, was previously detected but is no longer detected, this set of troubleshooting steps will attempt to get the drive detected again, or to conclude whether the drive has failed and should be replaced. Once you connect a new Serial ATA drive in your computer, there remains more to do to get your drive working.Please remember that these third-party programs do not have proprietary access to Seagate hard disk information, and therefore often provide inconsistent and inaccurate results. SeaTools is more consistent and more accurate and is the standard Seagate uses to determine hard drive failure.

Extended Capacity ManagerDe software installeert een apparaatstuurprogramma om de volledige capaciteit te kunnen benutten op verouderde BIOS-systemen. It will take you through a process of several steps, including partitioning and formatting the drive. You can choose the default setting - one big partition - or choose to partition the drive into multiple different partitions, as you prefer. It will then install Windows.After you install a device or update a driver for a device, Windows Vista or Windows 7 may not start See also Document ID: 196169 for more information on installing drives and Document ID: 188411 about the proper drivers in Windows. Generally, if a SATA drive is configured as the bootable drive, then the computer relies on that drive to boot the computer and to launch Windows. It is the source of most of the computer's operations. So, if the computer suddenly stops detecting the bootable drive, this will almost certainly mean that the computer will fail to boot at all. Instead, some error message will occur, and it will become obvious that a serious problem has occurred.