16 Amp Double Pole Pull Switch With Neon

Product Information

Step 1 – Before doing anything, turn off the circuit you are working on in the consumer unit or fuse box by turning off the MCB or pulling out the fuse. Most of these types of switch include a neon indicator, which will glow red or orange. If you have switched off the supply correctly the indicator will not be lit. Standard 6amp pull cord switch Tools and Materials Needed for Repairing and Replacing a Pull Cord Switch For the first part of this guide we will work through replacing a standard 6 amp pull cord light switch. From step 6 we will explain changing a 45 amp isolation switch. Step 1 – Isolate the Switch and Circuit If this does not work, then the switch must be replaced (see Replacing the switch section above). Repairing a 45 amp Pull Switch

In most cases, the 45 amp version will have an integrated light and/or on/off indicator that states when the appliance is live and also turned on.

To fit a pull cord switch or indeed just replace the cord, you will need the following tools and products. Step 4 – Supporting the switch with one hand, try to operate the pull cord with the other hand to see if the maintenance spray has freed up the spring and therefore the switch should work properly again Any work other than this must be carried out by a professional electrician with the necessary knowledge to do the work to the regulation standards and also be able fully test it and then issue a minor works certificate once completed.

Step 2 – Undo the two retaining screws holding the switch in place and carefully pull it down a little. There should be sufficient wiring to allow you to do this as with the lighter duty switch above If you just want to replace your broken pull cord switch then work through the steps below. However, if you want to have a go at repairing your existing switch then scroll down to the sections we have on repair. As stated, in the majority of cases they are used in areas subject to water and moisture as the fact that you have a pull cord to turn the light or appliance on and off you are no where near any electrical internals that could easily have water splashed onto them causing serious electrical injury.Pull cord switches are very handy items as they can be used in a variety of situations such as bathrooms and the similar where a standard tumble-type switch cannot be used. These rules absolutely do apply to DIY activities, so anyone carrying out notifiable work (anything other than the points listed) will have to submit a building notice to the local authority before starting the job and pay a fee to have the work inspected and tested, or simply avoid all the hassle and get a Part P electrician to do it. If this is ignored then you may face problems when trying to sell your property as if its had notifiable electrical work carried out, but for which the appropriate certificate from a qualified electrician cannot be produced. Additionally, it will also propably invalidate your home insurance. To do this, turn off the MCB of the lighting circuit you’re working on or if a fuse board, pull out the fuse.

One thing to note however is that the switches do differ slightly. Whereas the 6 amp switch is single pole, the 45 amp switch will be double pole as it needs to be able to isolate both the live and neutral. If you want to try and save your broken switch, rather than throw it away and replace it with a new one, work through the steps below for your chosen type of switch. Repairing a 6amp Pull Cord Light Switch Form a knot and then lower the finial to cover it. Other types of finial are available, such as timber or porcelain/ceramic, from hardware or DIY stores. Using a flat blade screwdriver, loosen each terminal for each wire and pull them free, ensuring terminals are loose enough to easily pull them out. The very first job to do before anything is to ensure the electricity is isolated for the circuit you will be working on.

Next, connect each wire in turn to the correct terminal according to the photo you took earlier. This should normally be Live brown/red to COM and neutral blue to L1.