Pro-Kleen Fresh Water Tank Cleaner (5 Litres) - Sanitises, Descales, Removes Algae & Bacteria - Prevents Stale Taste & Odours

Product Information

Complete a Disinfection Label for each tank and indicate if down services were included in the process.

It’s a good idea to change your water filters now too, so the whole system is clean and ready to go, although if you’re going into winter storage you might want to wait until the new season.

Water Tank Cleaning Process

Once the system has been flushed through or partly drained the TDS should be measured and the levels should be equivalent to the incoming mains water supply (TDS within 5%). Also, measure the concentration of free chlorine remaining in the tank. It should be between 0.5 and 0.1PPM. Many people ask me if the water tastes weird with the filter, but no- I can’t taste any difference tbh. Fill the tank with fresh water, allow to stand for 30 minutes and then flush the entire system again until you can’t smell bleach.

Water Purification, Cleanses water systems and tanks. Water purification is the process of removing undesirable chemicals, biological contaminants, suspended solids and gases from contaminated water.Use a power washer. You can also use a power washer to clean the inside of your water tank. You can use the power washer by itself or in conjunction with scrubbing the inside of the tank, depending how tough the sediment and residue is to remove. [3] X Research source Pressure washers come in a variety of sizes and strengths, but one with a pressure range between 1,300 and 2,400 psi works best for most household tasks. Follow these steps to clean the inside of your tank with a power washer: Cleaning and disinfecting your tank can result in a lot of water waste. Letting too much water out at one time can cause erosion or flooding, so it’s important that the water follows a channel to its final disposal point. Water tank disinfection is most effective when you use an anti-bacterial spray or add 5mL liquid bleach for every litre of water in the tank Where testing all taps/showers is not possible or practical, as a minimum, test the sentinels at the end of each pipe-run along with a proportionate number of outlets along each leg.