Birdgo Solar Panel Roof Mesh Fixing Clips - No Drill Installation of Bird Proofing Mesh to Stop Pigeon Bird Access (Nylon, Pack of 10)

Product Information

For outer corners, cut the solar panel pigeon proofing wire or weld mesh upwards from the bottom until the bend point and cover any gaps with a corner piece. For inner corners, cut the solar panel pigeon proofing wire or weld mesh upwards and secure any overlapped sections with cable ties.

STEP 3: Slide the speed washer onto the shaft of the clip assembly until snug. Make adjustments to the screen as necessary. Tighten the ratchet washer as required. The patent-pending plastic clips are not only UV stable but also gentle on anodised frames of solar panels, ensuring longevity. Installation is easy with the spacing of two clips per 450mm (18 inches) on shorter edges and three on longer ones, meaning the mesh is secure without drilling holes or harming the system. Constructed to accommodate the Solar Panel Mesh (WM132), the clips are almost invisible from ground level. Features & Benefits: Solar Panel Mesh Wire Clip Simply place the solar panel pigeon proofing wire or weld mesh nylon clips every 30-40cm along the solar panel frame and pull tight. Roll out the wire mesh or weld mesh and cut it into manageable lengths, then position the wire mesh or weld mesh in place, ensuring the fastening rod points upwards. Attach the fastening washer and join the next section of wire mesh or weld mesh with cable ties. STEP 3: Slide the speed washer onto the shaft of the clip assembly until snug. Make adjustments to the screen as necessary. Tighten speed washer to panel edge.Weldmesh is technically more difficult and time-consuming than other options, and subject to how the system is installed can be more expensive. This system, however, is permanent and failure is extremely unlikely. The SolarFix system is designed specifically to keep all birds from getting under solar arrays, protecting the roof, wiring, and equipment from their damage. This non-penetrating system is fast and easy to install, and can be removed for service. STEP 2: Set the wire mesh screen in place. Make sure the fastener rod comes through the screen at an upward angle as to keep downward pressure on the screen.

These clips are easy to install and effectively deter pigeons from roosting or nesting on your panels. Crafted from durable, weather-resistant materials, they provide long-lasting protection.

Follow No More Birds

A typical solar panel is approximately 1.6m tall and 1m wide, on a typical panel one should use 3 clips on each long edge and 2 clips on each short edge. See the diagram attached to this product listing for more details and an example of a typical installation. the presence of wildlife and debris can cause structural damage. For instance, rodents can chew through the wiring or debris can accumulate moisture, leading to potential corrosion on the roof.