STC-1000

Product Information

The price is a bit higher –The Elitech STC-1000 is about 5 usd more expensive than the generic version

If it’s too hot, the controller will turn on a cooling device. Electrical current will flow to the refrigerator to cool down the fermentation vessel. Once you’ve wired the controller, calibrate it. This is a straightforward process that involves immersing the heat probe in ice-cold water until it reaches a stable temperature.Nejlepší použití digitálniho regulátoru teploty STC-1000 je v líhních, inkubátoru, péči o zvířata citlivých na správnou teplotu jako v akváriu. Je to dobré v kotlích pro ohřev vody nebo v chladničkách a mrazničkách, DIY projekty, byly použity v mnoha keezerech, kegerátorech a fermentorech. Podrobný popis termostatu STC 1000 We’re a team of passionate brewers & distillers who want to share our learnings with others – helping answer some of the questions we had to figure out the hard way! The actual shape of the workpiece iscaptured on the machine using Starrag’sown 5-axis measuring cycles. It is recommended that you close the Arduino IDE once the sketch is uploaded and disconnect the programmer from the computer. Elitech STC-1000X temperature controller features cooling and heating modes with automatic switch, temperature unit switch between Celsius and Fahrenheit, temperature control by set-point and differential, temperature calibration, cooling output protection delay, sensor fault alarm and other functions. The controller reserves an interface of RS-485 communication function for further connection to an Elitech IoT module which makes remote control available. Specification Power Supply

The NC program can then be specificallyadapted or created anew – reliablyand fully automated. This technologyprovides advantages for a multitude ofapplications:

Když se teplota zvýší na cílovou teplotu, například 30 stupňů relé pro topení, vypne se. Pokud teplota dále stoupne a přesáhne 31 stupňů, relé chlazení se zapne.

It has functions of temperature measurement, temperature display, temperature control, temperature correction, sensor fault alarm, over-temperature range alarm, compressor protection delay.When the temperature is raised to a target temperature of, for example, 30 degrees of the relay for heating, it is switched off ,If the temperature rises further and exceeds 31 degrees, the cooling relay switches on. The exact same thing as the normal STC-1000+ firmware, except profile is updated every minute instead of every hour. Same variations of extra featured versions. STC-1000+ OVBSC (one vessel brew system controller) firmware