EASYSEAL Sandstone Seal+ENHAN 5LT

Product Information

Briefly open then close high side valve of the manifold gauge set to allow a little high side liquid to flow through the yellow hose and EasySeal Ultimate tube. With high side valve of the manifold gauge set closed, wait one minute for the yellow hose and EasySeal Ultimate to equalize to suction pressure. Disconnect EasySeal Ultimate from suction service port and from manifold gauge set. Discard or recycle empty injector.

A/C EasySeal is designed to prevent as well as repair leaks anywhere in the system, including condensers, evaporators, copper lines, and soldered joints. It is easily injected into the system, traveling with the refrigerant, searching for leaks. The fact that A/C EasySeal travels with the refrigerant is very important to its ability to find leaks faster, using less sealant than those sealants designed to mix and travel with the systems oil.The EasySeal self-adhesive roofing system has been designed to remove the requirement for hot bitumen and or naked flames for anyone installing roofing membranes. EasySeal is a two-layer high performance system, which was originally developed for small roofs, such as those over garages, porches, extensions and dormer windows etc. However, the fire-safe benefits of EasySeal are equally applicable for large projects. The self-adhesive application process, using no hot bitumen, gas torches or large amounts of messy liquids, makes it an ideal option for experienced contractors or competent DIY installers alike. This product is not suitable if surfaces have been treated previously with a silicon or stearate based water repellent A minimum of 3 months should be left after the installation of a new driveway or patio before sealing to ensure that any efflorescence or staining has had time to dissipate

Work diagonally across the joints, in straight lines & in one direction, do not allow the material to pool Attach other end of charging hose to low side service port. As this is done, there will be a very small release of system charge that will purge air from the hose. Apply generous even coats with a long pile roller to the natural stone at a coverage rate of 4-5m2 per litre. Do not allow the product to pool or the final appearance may not be even in colour on the paving to be enhanced and sealedExternal wall cladding requires protection from the weather and pollution and we can offer a range of coating systems which will protect most surfaces from plastic-coated metal cladding to Asbestos wall cladding sheeting. Manufactured from a polyester base with an SBS (Styrene Butadiene Styrene) bitumen coating, this Easyseal roofing top sheet also features an upper surface with a special finishing of slate mineral. The release film protects the underneath of the sheet and can easily be removed with ease when installing to BS 8217: 2005, 'Code of Practice for Reinforced bitumen membranes for roofing' and IKO fixing guidelines. Features & Benefits: IKO Easyseal / Coldseal Self-Adhesive Top Sheet Roofing Felt - 6m x 1m