About this deal
Contents Four 12′ anodized aluminum spring-loaded poles with parts (heads, plates, and GripDisk™ non-slip pads), two standard zippers, and one carry bag. Plastic sheeting is not included. It contains everything you need to create a dust barrier up to 16 feet wide and seal it on all four sides. Complete with carry bags, this kit is reusable and works with drop-ceilings.
Seal your barrier at the ceiling and floor with a Span™ attached to the top and bottom of a pole. You’ll need two poles, two floor adaptors, and four Spans. With plastic sheeting, create an entry using ZipWall® zippers. With reusable panels, use the 2.5 foot panel as a door. Seal each wall using one Span™ and a SidePress™. Add a FoamRail™ and SidePress™ if the wall is higher than 8 feet Set up the barrier one pole at a time starting at the wall. Leave the plastic loose at the bottom and make sure the spring at the top of the pole is not compressed all the way.With a plastic sheeting barrier, create an entry using ZipWall® zippers; with a ZipFast™ reusable barrier, use the 2.5 foot panel as a door.
If tight sealing is required, use FoamRail™ and Span™ tape less seals along the ceiling, walls, and/or floor. Six 12′ anodised aluminium spring-loaded poles with parts (heads, plates, and Gripdisk™ non-slip pads). Plastic sheeting is not included. Tips for setting up a dust barrier:Contains Two 20′ anodised aluminium spring-loaded poles with parts (heads, plates, and GripDisk™ non-slip pads). Plastic sheeting is not included. If tight sealing is required, use FoamRail™ and Span™ tapeless seals along the ceiling, walls, and/or floor.