Cable Matters (1/4 Inch) 6.35mm XLR to Jack Cable 0.9 m Male to Male (Jack to XLR Cable, XLR to 6.35mm Cable, TRS to XLR Cable)

Product Information

Of all three, it’s the ring that is particularly important as this is what grounds the signal and helps create a higher level of audio quality. Pros Versatility. TRS cable is a standard choice for musical instruments such as guitars, keyboards, and synthesizers. While keyboard workstations are now supporting XLR connectors, there are still lots of instruments that only support TRS connectors.

Before we start looking at their differences, let’s take a moment to look at what TRS and XLR cables have in common. Each end of a TRS cable has the same connector, so there’s no need to worry about pairing males and females together. Cons Unsecure. TRS cable connection tends to get loose over time due to its plug-unplug nature of usage. It also makes the cable prone to getting detached from the connection. This means that, although you’ll get a better signal since it’s grounded, it’s slightly weaker than the signal achieved by an XLR. What is XLR? Another advantage of TRS connectors is that they are unbalanced, which makes them easier to install and use than XLR connectors. This is because unbalanced connectors only require two wires rather than three. Cons of TRS Sound Quality

Basic similarities of TRS and XLR cables

Cables vary quite a bit in their length, and obviously, your decision will depend heavily on your needs and your studio set up. The general rule of thumb is, the shorter the cable, the better. It’s a no brainer that the length of the cable is how far the signal has to carry to get to its destination. The shorter the cable, the less time a signal transmission has to be interrupted. XLR connectors are used to transmit mainly balanced mono audio but sometimes stereo signals, from one device to another, whereas TRS connectors are used for headphones and unbalanced stereo connections. Basic Similarities

Gotham Audio is another leader in audio cable production. Originating in Germany and now located in Switzerland, their only goal has been to minimize noise and interference since 1976. Gotham also has superior quality cables, but for a very reasonable price. The company has experienced a lot of changes in leadership over the last couple of decades but consistently delivers on crisp sound and quality. Canare Corporation TRS Is More Affordable and Ubiquitous: Although XLR is more robust, tougher, and less susceptible to shorts, TRS is a more widespread cable connector type because it’s so cheap. You’re likelier to avail of a TRS for balanced single channel, stereo, mono, and high-level speaker connections. This ubiquitous nature is the reason why it creates a higher risk of incorrect linkages though. XLR has a more limited application, which is balanced line-level audio. There are several key factors to consider when comparing the sound quality of XLR and TRS connectors. These include the balance of the connector, the signal level, the cable length, and the type of audio equipment. How XLR & TRS Connectors Differ in These Factors Balance The XLR connector (also Cannon plug and Cannon connector) was invented by James H. Cannon, founder of the Cannon Electric company, Los Angeles, California. The XLR connector originated from the Cannon X series of connectors; by 1950, a latching mechanism was added to the connector, which produced the Cannon XL model of connector, and by 1955, the female connector featured synthetic-rubber insulation polychloroprene (neoprene), identified with the part-number prefix XLR. There was also the XLP series of connectors with hard plastic insulation, but the XLR model name is commonly used for all of the variants. [2] [3] [4]Both these connectors are common in the audio industry for connecting microphones, headphones, and other audio equipment. Despite their different designs and uses, XLR and TRS connectors have some similarities in terms of sound quality.